Splitting the half shafts from the hub/trailing-arm/bearing assembly was painful and Autotechnix in Doncaster did a good job to help me out on this one.
Reassembling is equally painful as I'm attempting to reassemble with the refurbished trailing arms back on the car.
Can anyone suggest;
- A good, but inexpensive tool to refit the rear wheel bearings and hub or suggest an easy technique?
- A technique to refit the splined shaft (the drive end of the half shaft) into the splined hub?
The hubs and bearings are new and the half shafts have been totally refurbished by CPL Drivelink, but the fit's are really quite tight.
Any help appreciated.
Reassembling is equally painful as I'm attempting to reassemble with the refurbished trailing arms back on the car.
Can anyone suggest;
- A good, but inexpensive tool to refit the rear wheel bearings and hub or suggest an easy technique?
- A technique to refit the splined shaft (the drive end of the half shaft) into the splined hub?
The hubs and bearings are new and the half shafts have been totally refurbished by CPL Drivelink, but the fit's are really quite tight.
Any help appreciated.